What's Included
- Electronic oven control (EOC) board replacement
- Bake and broil element replacement
- Temperature sensor calibration and replacement
- Steam generator service and descaling
- Door hinge, latch, and lock mechanism repair
- Convection fan motor replacement
Thermador Professional and Masterpiece wall ovens bring together true convection, steam cooking, and the PreciseBake and PureConvection modes that serious home cooks rely on. When error codes F1 through F62 appear, the oven fails to reach temperature, or the Steam and Combi system faults out, professional repair restores the cooking precision these ovens deliver.
Common Thermador Wall Oven Problems
- Oven not heating or not reaching set temperature
- F1, F2, or F3 error codes on control panel
- Self-clean cycle failing to start or door stuck locked after cleaning
- Steam oven not generating steam (PSO series)
- Convection fan running continuously or making noise
- Door not closing flush or heat escaping at door seal
Error Codes We Diagnose
We diagnose all Thermador wall oven fault codes: F1 (EOC board fault), F2 (overtemperature), F3 (temperature sensor open), F4 (sensor short), F7 (keypad stuck), F9 (door lock), F34 (relay board), F62 (fan circuit), F1-E0 (EEPROM error), and the FC communication fault. We diagnose to component level before ordering any part.
Models We Service
We service the full Thermador oven lineup: Professional Series single and double wall ovens (POD301, POD302), Masterpiece Series (MED301, MED302), the Steam and Convection line (MESO30, PSO301), and MicroCombi combination units. All oven widths from 27" to 30" are covered across all generations.
Steam Oven Expertise
Thermador Steam and Combination ovens (PSO series) require technicians familiar with steam generator systems, water inlet valves, and the steam cavity sealing that prevents moisture infiltration into the oven electronics. Our technicians are trained on BSH steam system architecture and carry steam generator components as standard stock.
Our Repair Process
- Inspect: Test all oven modes, check door seal and hinge condition
- Test: Retrieve fault codes, test element resistance, check sensor values
- Diagnose: Confirm component root cause
- Estimate: Written repair cost before work begins
- Repair: Replace faulty part, calibrate temperature, test all cooking modes
Transparent Pricing
Thermador oven repairs start from $155 for element and sensor replacements. EOC board and steam generator work starts from $285. All pricing confirmed in writing before any repair begins.